1. Keep the work site clean. After each organic fertilizer equipment test, remove the bottom to remove the granulation leaves and residual plastic sand inside and outside the granulation pot, clean the plastic sand and flying objects scattered or splashed on the organic fertilizer equipment, and remove the organic fertilizer. The exposed processing surface of the equipment and machine is wiped clean, coated with anti-rust paint, and put on a corresponding protective cover to prevent secondary intrusion of dust.
2. The organic fertilizer equipment has no external oil hole, and the gears and worm gears are lubricated with special butter for organic fertilizer equipment. The upper gear and the lower gear should be filled with three-in-one butter once every season, and the cover of the moving gear box and the cover of the transmission gear can be opened respectively when refueling). Oil should be dripped into the sliding surface between the supporting gear box and the bracket hinge frequently for lubrication. The worm gear box and bearings have been filled with enough transmission grease when they leave the factory, but after every one year of use, the gearbox machine should be removed and cleaned once, and all protective lubricants should be replaced.
3. Always pay attention to the operation of the organic fertilizer equipment. There should be no serious abnormal noise, and there should be no metal friction sound. If any abnormality is found, stop using it immediately, check it, and use it after troubleshooting. The reason is that the machine cannot be started. If there is metal friction sound, first check the gap between the organic fertilizer equipment.
4. Frequently check the standard clearance between organic fertilizer equipment.
5. When overhauling organic fertilizer equipment, the working gap should be re-measured each time, and adjusted several times, and can only be used after meeting the standards.
6. If the organic fertilizer equipment cannot be operated by pressing the program controller, check the power supply voltage, power plug socket, connecting plug socket, etc., and check the internal fault of the controller.
Post time: Feb-27-2023
